Sport Winter

Snow removal made quick and easy.  This winch operated snowplow allows you to remove snow from your driveway or parking lot from the comfort of your Utility Vehicle.  Robust one-piece swivel design for simplicity and strength. When not in use, the snow blade can be easily removed and stored away. ​

Features:​

• Adjustable 60-72 inch 3-piece plow

• Heavy Duty 11-gauge steel construction​

• Easy to install and operate​

• Utilizes existing winch for lifting and lowering blade​

• Adjustable plowing angles: +/-30° angle adjustment in 15° increments

Framed textile door uppers fit snugly into vehicle door jamb sealed by automotive grade bulb weather strip. Clear vinyl windows open and close with heavy duty double pull zippers. Installs quickly and easily in minutes and forms an industry best full cab weather seal when combined with AXIS Hard Top, Windshield and Rear Panel (sold separately). Quickly bolts right up to preset hard mounting points on the vehicle – no cutting or drilling required. ​

​Features:​

• Sturdy Steel Frame—Designed & engineered for a tight fit into the vehicle's door jamb​

• Durable PVC Coated Polyester Textile with Optical Grade PVC Windows – quality materials that will perform in the harshest conditions​

• Dual Zippered Window Pulls—Provide multiple open positions for venting options.​

• Integrated Window Storage Straps—Keeps windows rolled and stowed out of the way.​

• Automotive Grade EPDM Foam Gasket—Conforms to contours of door perimeter providing excellent seal and easier closing.​

• Industry best weather sealed cabin - when combined with factory roof along with front

Constructed of durable, optical-grade, .236” UV Protected Polycarbonate. Provides great visibility and reliable protection from dust, wind, weather, off-road hazards and cargo shifting in the cargo bed. Installs quickly and easily in mere seconds using Quick Snap toolless clamps seating securely within a recess formed by the AXIS vehicle frame. The full perimeter automotive grade bulb seal creates a superior fit and seal for maximum comfort and protection.

Features​

• .236” UV Resistant Polycarbonate— Thick, shatter- proof, and non yellowing​

• Toolless Mounting Clamps—Quickly snap on or off the cage and in less than a minute​

• Full Perimeter Automotive Grade Bulb Gasket—Creates a full perimeter weather tight seal​

• Trailerable—Up to 65mph when properly prepared​

• Reduces blow-back into the cab​

• Designed & engineered to work factory roof, and doors to form complete enclosure​

The Firestorm Gen ii Tech Heater system features an highly efficient exchanger design to minimize heat dissipation compared to older generation heaters. The result is maximum heat consistency and higher BTU ratings. This heater will keep your sealed cab comfortably warm in the most extreme cold conditions. Designed and Engineered as an integrated solution, there are 4 dash vents and switch that inserts into one of the pre-set switch knock outs on the dash switch panel. The result is a factory level installation solution and not a box bolted to the floor. Adjustable vents provide maximum directional options to get the heat where you need it. Top vents can be used for defrost as well as directional heat, and bottom vents can heat your legs and feet. ​

​Features:​

• Fully integrated heating solution with dash vents and switch​

• Concealed heat exchanger installation doesn’t interfere with foot room in Cab​

• 2 Position HI/Low Switch​

• Gen ii Exchanger with higher BTU’s and heat consistency over Gen 1 units​

• Four x 50mm full adjustable dash vents Total​

• Two 50mm Upper Dash Vents for heat and/or Defrost function​

• Two 50mm Lower Dash Vents for legs and feet heating